Lightolier FAEM3 User Manual download pdf

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixtur

e is intended for installation in accordance with the National Electrical Code and local

regulations. To assure full compliance with local codes and regulations, check with your local electrical

inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

NSTRUCTION SHEET NO.

IS:FAEM3

C0506 Page 1 of 4

IMPORTANT SAFEGUARDS

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD BE FOLLOWED INCLUDING THE FOLLOWING:

1. TURN OFF AC POWER BEFORE PROCEEDING.

2. DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR WIRING COMPARTMENT, NOR ABOVE FIX-

TURE IN SUCH A MANNER AS TO ENTRAP HEAT.

3. BE SURE ALL ELECTRICAL CONNECTIONS ARE COMPLETE AND THE JUNCTION BOX IS CLOSED BEFORE INVERTER

CONNECTORS (LOCATED IN THE SWITCH/INDICATOR LIGHT BOX) ARE CONNECTED.

4. DO NOT USE OUTDOORS.

5. DO NOT LET POWER SUPPLY CORDS TOUCH HOT SURFACES.

6. DO NOT MOUNT NEAR GAS OR ELECTRICAL HEATERS.

7. USE CAUTION WHEN SERVICING BATTERIES. CONTAINS NICKEL-CADMIUM RECHARGEABLE BATTERY. MUST BE

RECYCLED OR DISPOSED OF PROPERLY. DO NOT SHORT CIRCUIT; MAY CAUSE BURNS.

8. EQUIPMENT SHOULD BE MOUNTED IN LOCATIONS AND AT A HEIGHT WHERE IT WILL NOT READILY BE SUBJECT TO

TAMPERING BY UNAUTHORIZED PERSONNEL.

9. THE USE OF ACCESSORY EQUIPMENT NOT RECOMMENDED BY THE MANUFACTURER MAY CAUSE AN UNSAFE

CONDITION.

10. DO NOT USE THIS EQUIPMENT FOR OTHER THAN INTENDED USE.

11. THIS UNIT HAS MORE THAN ONE POWER SUPPLY CONNECTION POINT. TO REDUCE THE RISK OF ELECTRICAL SHOCK,

DISCONNECT BOTH NORMAL AND EMERGENCY POWER SUPPLIES BEFORE SERVICING.

12. BEFORE SERVICING TO PREVENT ELECTRICAL SHOCK, DISCONNECT THE INVERTER CONNECTORS OF THE EMER-

GENCY BATTERY PACK (LOCATED IN THE SWITCH/INDICATOR LIGHT BOX). MAKE CERTAIN THAT THE SWITCHED (IF

THE FIXTURE IS SWITCHED) AND THE UNSWITCHED LINE TO THE EMERGENCY BATTERY PACK ARE TURNED OFF AT

THE FUSE BOX. SER

VICING SHOULD BE PERFORMED BY QUALIFIED SER

VICE PERSONNEL ONLY.

13. BEFORE ANY INSTALLATION, MAKE SURE TO CHECK THE COMPATIBILITY MATRIX BELOW BEFORE INSTALLATION.

INCORRECT MATCHING MAY CAUSE ELECTRICAL SHOCK AND DAMAGE TO BALLASTS AND LAMPS. FOR USE WITH

NON-DIMMING (U SERIES) AND DIMMING (J-SERIES) FRAME-IN KITS.

Installation of Compact Fluorescent Emergency Ballast Accessory FAEM3E to

Standard Calculite Four-Pin Electronic Compact Fluorescent Lamp Frame-In Kit

SAVE THESE INSTRUCTIONS

LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA 02720

Emergency Ballast Lamp Wattage Compatible Ballast

13W

Quad Tube 4-Pin

18W

A-EM3E

26W

Triple Tube 4-Pin

18W

26W

32W

42W

Electroninc Non-Dimming

Advance Mark 7 and Mark 10 (Dimming)

Lutron compact SE, Hi-Lume,

TU-Wire (Dimming)

1 2 3 4

IS:FAEM3 1

Summary of Contents

Page 1 - IS:FAEM3

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTUREThis fixture is intended for installation in accordance with the National Electrical C

Page 2

A. INSTALLING EMERGENCY BALLAST TO STANDARD FRAME-IN KIT (Fig. 1 and 8).1. Before placing FRAME-IN KIT in the ceiling, install EMERGENCY BALLAST to

Page 3

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTUREThis fixture is intended for installation in accordance with the National Electrical C

Page 4

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTUREThis fixture is intended for installation in accordance with the National Electrical C

Comments to this Manuals

No comments

Lightolier FAEM3 User Manual

Browse online or download User Manual for Power adapters & inverters Lightolier FAEM3. Lightolier FAEM3 User's Manual

Summary of Contents

Comments to this Manuals