Lightolier IS:40825 User Manual download pdf

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.

To assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

LIGHTOLIER a GENLYTE company.

631 Airport Road, Fall River, MA 02720

INSTRUCTION SHEET NO.

IS:40825

0998 Page 1 of 1

INSTRUCTION SHEET FOR INSTALLATION OF BOWSHIELD

™

“ADA” WALL BRACKET SERIES

NOTE: This instruction sheet covers several fixture

styles. Backplate, lamp type and diffuser assembly

may vary slightly from that shown, although installa-

tion is the same.

BACKPLATE INSTALLATION:

1. Thread CROSSBAR MOUNTING SCREWS into CROSSBAR as

shown (Fig. 1).

2. Using appropriate slots in CROSSBAR, secure CROSSBAR to

OUTLET BOX using OUTLET BOX SCREWS (provided with

OUTLET BOX.)

3. While supporting BACKPLATE ASSEMBLY make connections:

black fixture lead or fixture lead without tracer marks to hot

(black) supply lead; white fixture lead or fixture lead with trac-

er marks to neutral (white) supply lead. Uninsulated fixture

wire is a ground wire and must be connected to grounding ter-

minal or ground lead inside OUTLET BOX. Use WIRE NUTS

(local hardware item). Push supply wires and connections back

into OUTLET BOX.

4. Position BACKPLATE over CROSSBAR

allowing CROSSBAR MOUNTING SCREWS

to come through holes in BACKPLATE ASSEMBLY.

5. Secure BACKPLATE ASSEMBLY in position by installing two

BATTERY NUTS over CROSSBAR MOUNTING SCREWS and

tighten.

6. Install recommended lamp(s).

DIFFUSER INSTALLATION:

1. Slide DIFFUSER down into NOTCHES in BACKPLATE ASSEM-

BLY until DIFFUSER rests in slot in support arm.

2. Secure DIFFUSER in position by tightening four DIFFUSER

MOUNTING SCREWS through holes in BACKPLATE ASSEM-

BLY against DIFFUSER. (Caution: Diffuser damage may occur;

do not over tighten diffuser mounting screws.)

CAUTION: MAXIMUM WATTAGE AS MARKED ON

FIXTURE MUST NOT BE EXCEEDED.

CAUTION: MAKE CERTAIN WIRES ARE NOT PINCHED

BETWEEN PARTS.

OUTLET BOX

WIRE NUT

GROUND WIRE

CROSS BAR

MOUNTING SCREW

OUTLET BOX SCREW

(PROVIDED WITH OUTLET BOX)

BATTERY NUT

SUPPORT ARM

SLOT

NOTCH

DIFFUSER

MOUNTING

SCREW

BACKPLATE

ASSEMBLY

DIFFUSER

WARNING: PUSH SUPPLY LEADS SECURELY INTO

JUNCTION BOX BEFORE PERMANENT

MOUNTING.

WARNING: FOR SUPPLY CONNECTIONS USE

WIRE RATED FOR AT LEAST 90˚C.

FIG. 1

WARNING: RISK OF FIRE. MOST DWELLINGS BUILT

BEFORE 1985 HAVE SUPPLY WIRE RATED 60˚C.

CONSULT A QUALIFIED ELECTRICIAN

BEFORE INSTALLING.

IS:40825 1

Summary of Contents

Page 1 - IS:40825

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTUREThis fixture is intended for installation in accordance with the National Electrical C

Comments to this Manuals

No comments

Lightolier IS:40825 User Manual

Browse online or download User Manual for Unknown Lightolier IS:40825. Lightolier IS:40825 User's Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Lightolier IS:40825