Lightolier Lytespan Track Lighting System 8276 User Manual download pdf

READ AND UNDERSTANDTHESE INSTRUCTIONSBEFOREINSTALLING FIXTURE

INSTRUCTION SHEET NO,

‘his fixture is intended for installationin accordancewith the National ElectricalCode and local

emulations.To assure full compliance with local codes and regulations, check with your local electrical

nspector before installation. To prevent electrical shock, turnoff electricity at fuse box before proceeding.

IS:8276

Retain these instructions for maintenance reference.

0892

Page 1 of 2

INSTRUCTIONS FOR ATTACHING LINEAR” ADAPTER TO LYTESPAN@ TRACK

FOR USE WITH LYTESPAN BASIC OR ADVENT TRACK SYSTEM ONLY

INSTRUCTIONSFORAllACHING LINEAR” TO SINGLE CIRCUITTRACK SYSTEMS

1. Insertinto LYlESPAN TRACK (see Fig. 1). LOCKINGLEVERmust be on the same side of track as BEAD.

2. Rotate FITTING90° clockwiseuntil LOCKINGLEVERsnaps and locksin place (see Fig.

2 and 3).

3. To remove: depress LOCKING LEVER, then rotate FITTING 90° counterclockwise.

YTESPANTRACK

FITTING

FIG. 1

FIG. 2

FIG. 3

INSTRUCTIONSFOR CONVERTINGFITTINGTO OPERATEON 2

BRASSCON

CIRCUITTRACK SYSTEMS

See Fig.4. BRASSCONTACTcan be raised or lowered.Brokenline indicates

LOCKING

position for 1 circuit or lower circuit of 2 circuit track system.

LEVER

To convert attachment FllTING for upper circuit of 2 circuit track, raise BRASS

CONTACT to high position by lifting CONTACT as high as stop permits and

CONTACT clicks into place.

SEE BACK FOR LAMPING

1- I <>1-1

TC> 14 E [2” ER’#E?lH’K~TR;;

1 2

r>READ AND UNDERSTANDTHESE INSTRUCTIONSBEFOREINSTALLING FIXTUREINSTRUCTION SHEET NO,‘his fixture is intended for installationin accordancewith the

INSTRUCTION SHEET NO.1S:82760892 Page20f2OPERATION1. AIMING ADJUSTMENTSSimply rotate LYTESPOT to the desired position as indicated in Fig. 1.FIG. 11.

No comments

Lightolier Lytespan Track Lighting System 8276 User Manual