Lightolier ProSpec IS:26600 User Manual download pdf

IS:26600

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING TRACK

This fixture is intended for installation in accordance with the National Electrical Code and local or Federal code

specifications. To assure full compliance with codes and regulations, check with your local electrical inspector

before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Save these instructions for maintenance reference

and refer to them when additions to or changes in the track configuration are made.

INSTRUCTION SHEET NO.

A0397 Page 1 of 4

FALL RIVER, MASSACHUSETTS 02720

MONTREAL, QUEBEC, CANADA

ProSpec™ track lighting is designed to support and energize ProSpec™ Lytespots

which can be

attached anywhere along the track. It is a four conductor system, continuously grounded through-

out, to be supplied by two single 120V, 20 amp, 60Hz branch circuits. It is not intended for use with

a power cord or convenience receptacles. ProSpec™ is listed by Underwriters Laboratories, Inc. It

may only be used with electrical fittings identified for use with ProSpec™ track.

Installation Instructions for ProSpec

™

Track Lighting--

Recessed Feed Track and Plain Track Units.

IMPORTANT SAFETY INSTRUCTIONS

Read all Track, Connector, Feed-in Kits, and Accessory Instruction Sheets before

installing any ProSpec

™ Track item. When installing or using this track system, basic

safety precautions should be followed:

Read all instructions before installing the track system.

• Do not install in wet media (concrete, plaster, etc.).

• This track system is intended for installation in accordance with the National

Electrical Code and Local or Federal Codes.

• Do not install this track in wet or damp locations.

• Do not install any part of this track system less than 5 feet above floor.

• Do not install any fixture assembly closer than 6 inches from any curtain, or similar

combustible material.

• To prevent electrical shock, turn off electricity at fuse box before installing the track

or adding to or changing the configuration of the track.

• Instructions for grounding per instruction sheet of the feed-in kit used must be

followed. Failure to do so may result in a hazardous condition.

• Use #12 ga. AWG solid wire only (not stranded wire) for supply to track.

• Observe polarity, white supply lead (neutral) to contact marked “NEUT” on screw

terminal connectors.

• Do not exceed 4 feet between mounting points.

• Do not attempt to energize anything other than track lighting fixtures on the track.

To reduce the risk of fire and electrical shock, do not attempt to connect power tools,

extension cords, appliances and the like to the track.

SAVE THESE INSTRUCTIONS

1 2 3 4

IS:26600 1

Summary of Contents

Page 1 - IS:26600

IS:26600READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING TRACKThis fixture is intended for installation in accordance with the National Electr

Page 2

IS:26600INSTRUCTION SHEET NO.A0397 Page 2 of 4Recessed ProSpec™ Track Mounting MethodsFIG. AFIG. BFIG. CFIG. DMOUNTING PROSPEC™ TRACKThere are three

Page 3

IS:26600INSTRUCTION SHEET NO.Instructions for Recessed ProSpec™ TrackPower Feed to TrackDIRECT POWER FEED TO "FEED" TRACKUse solid 12 ga. co

Page 4

FIELD CUTTING TRACK•Remove and save the Dead End Cover.•Cut the track using a metal cutting blade (preferably in a miter box toobtain a square cut)•Re

Comments to this Manuals

No comments

Lightolier ProSpec IS:26600 User Manual

Browse online or download User Manual for Unknown Lightolier ProSpec IS:26600. Lightolier ProSpec IS:26600 User's Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Lightolier ProSpec IS:26600