Lightolier Fluorescent Downlight and Wall Washer User Manual download pdf

—

INSTALLATION OF COMPACT FLUORESCENT

DOWNLIGHTS AND WALL WASHERS

INSTRUCTION SHEET NO.

IS:8054CL

0891 Page 1 of 2

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE. -

This fixture is intended for installation in accordance with the National Electrical Code and local

regulations. To assure full compliance with local codes and regulations,

check with your local electrical

inspector before installation. To prevent electrical shock, turn off electricity at fuse box before

proceeding. This fixture is intended for ceiling mounting and is suitable for damp locations.

Retain these Instructions for maintenance reference. -

INSTALLATION OF DOWNLIGHT

A. INSTALL WHITE TRIM RING

NOTE

Omit this sactlon If reflector is self-flenged.

1. For overlappin trim installation (Fig. 1), slip WHITE TRIM RING

over REFLEC#R, as shown in Fig. 2 and 3.

2. For flangeless trim installation (Fig. 4), WHITE TRIM RING is not

required.

B. SNABIN

Align TABS on SOCKET CUP with openings in REFLECTORand

push in SOCKET CUP until RETAINING SPRING snaps in (Fig. 5).

C. PUSH-UP REFLECTOR

Tilt REFLECTOR and insert SOCKET CUP into ceiling opening on

side opposite JUNCTION BOX. Pivot REFLECTOR and push it up

into ceiling (Fig. 6).

N~E To remove REFLECTOR, disengsge the SOCKET CUP by

depressing the RETAINING SPRING (Fig. 5). Turn REFLECTOR

counterolockwlse while pulling downward. After starting, use

both hands to ramov~ If desired. See Fig. 7.

D. LAMPING

lnserI lamp, tip first through hole in side of reflector opposite lamp

SOCKETS. Bring lamp to horizontal position, line up pins, and push

into socket (Fig.8). To relamp, carefully pull straight out of socket, tilt

base downward, and remove lamp.

INSTALLATION OF LENS WALL WASHER AND OPEN

WALL WASHER

NOTE. aafore Installing reflector,make sure the mountingframe IS

Installedwith

JUNCTION BOX away from the wall to ba illuminated

(Fig. 10A or 10B).

FOR OPEN WALL WASHER

Remove two RETAINING SPRINGS that are near the JUNCTION BOX from

the MOUNTING FRAME (Fig 9).

Insert two new RETAINING SPRINGS, that are provided with the reflector

trim, into pocket of MOUNTING FRAME (Fig. 9A).

Then squeeze RETAINING SPRING into position with a plier (Fig. 9A).

FIG. 1

,,$y

.—.-

/“

REFLECTOR

OR LENS TRIM

WHITE

TRIM

RING

FIG. 2

FIG. 3

:: .:.

,4.,..,-.

,,. ..

FK3. 4

FIG. 5

TO REMOVE

““E=Jum

RETAINING

SPRING

REMOVED

1 m

FIG. 9 FIG. 9A

wREFLEcTOR

FIG. 6 FIG.

SOCKET

—

,.,,

—

,..

..+jf’

.,5-;:::’;+’

‘..:>~’ ,, ,.

,, ,,,

,,,,,,

,.:,

~x.,:s

FIG. 8

1 2

IS:8054CL 1
-Qi-REFLEcTOR 2

Summary of Contents

Page 1 - IS:8054CL

—INSTALLATION OF COMPACT FLUORESCENTDOWNLIGHTS AND WALL WASHERSINSTRUCTION SHEET NO.\IS:8054CL0891 Page 1 of 2READ AND UNDERSTAND THESE INSTRUCTIONS B

Page 2 - -Qi-REFLEcTOR

lNSTALIATION OF COMPACT FLUORESCENTDOWN LIGHTS AND WALL WASHERS (CONT’D);2;~54CLPage 2 of 2A. SNAPINAlign TABS on SOCKET CUP with openings in reflecto

Comments to this Manuals

No comments

Lightolier Fluorescent Downlight and Wall Washer User Manual

Browse online or download User Manual for Wall clocks Lightolier Fluorescent Downlight and Wall Washer. Lightolier Fluorescent Downlight and Wall Washer User's Manual

Summary of Contents

Comments to this Manuals